燃氣發電機組與柴油發電機組一樣，在操作使用時需要注意一些事項，必須注意這些事項才能更好地利用燃氣發電機組做好人的工作。那么，下面就來了解一下停電測試燃氣發電機運行狀態順利。

Like diesel generator sets, gas generator sets need to pay attention to some matters during operation and use, which must be paid attention to in order to make better use of gas generator sets to do good work. Then, let's take a look at the power failure test and the smooth operation of the gas generator.

接到停電通知時，請提前測試燃氣發電機運行狀態，確保停電時正常運行。出發的順序如下。

When receiving the power failure notice, please test the operation status of the gas generator one day in advance to ensure the normal operation during the power failure. The order of departure is as follows.

1、檢查氣壓、潤滑油液位、兩油箱冷卻液液位，

1. Check the air pressure, lubricating oil level and coolant level of two oil tanks,

2、將發電機自動狀態切換到手動狀態切換開關從3點方向左轉至12點方向進入手動狀態;

2. Switch the automatic state of the generator to the manual state, and turn the universal switch from 3 o'clock to 12 o'clock to enter the manual state;

3、關閉左下發電機斷路器;將電路斷路器的把手向下方放倒，極其斷開;

3. Close the lower left generator circuit breaker; Turn the handle of the circuit breaker down and disconnect it extremely;

4、啟動發電機;將切換開關從12點方轉到6點方向，即為點火啟動設備。

4. Start the generator; Turn the universal switch from 12 o'clock to 6 o'clock, which is the ignition starting device.

5、機器啟動運行后，請注意電壓400V、頻率50HZ、轉速1500轉。運行10分鐘，水溫上升到60時，將切換開關從6點方向轉至9點方向，進入待機運行狀態，5分鐘后機器自動停止;

5. After starting the machine, please pay attention to the voltage of 400V, the frequency of 50HZ, and the speed of 1500 rpm. After running for 10 minutes, when the water temperature rises to 60, turn the universal switch from 6 o'clock to 9 o'clock, and enter the standby operation state. After 5 minutes, the machine automatically stops;

測試結束后，請恢復斷路器的接通狀態，將切換開關從燃氣發電機組的9點到3點方向轉動。更多相關內容就來我們網站http://www.cxxrdz.com咨詢！

After the test, please restore the circuit breaker to the ON state and turn the universal switch from 9:00 to 3:00 of the gas generator set. Come to our website for more relevant content http://www.cxxrdz.com consulting service