Gas system:

燃氣管路為LNG氣瓶--汽化器—GVU(低壓燃氣濾清器—減壓器--低壓電磁閥)-發動機；GVU到發動機混合器的管路、GVU箱、GVU內附件由發動機廠家提供。自低壓燃氣濾清器開始，到發動機的管路和接頭均隨發動機提供；LNG氣瓶提供給發動機的穩定燃氣壓力范圍根據為WP4/WP6/WP10系列4~7bar，170系列不低于8bar。低壓燃氣濾清器之前的燃氣管路內徑不低于Ф10。

The gas pipeline is LNG cylinder vaporizer GVU (low pressure gas filter pressure reducer low pressure solenoid valve) - engine; the pipeline from GVU to engine mixer, GVU box and accessories in GVU are provided by engine manufacturer. Starting from the low-pressure gas filter, the pipeline and joint to the engine are provided with the engine; the stable gas pressure range provided by LNG cylinder to the engine is 4 ~ 7 bar for wp4 / WP6 / WP10 series, and not less than 8 bar for 170 series. The inner diameter of gas pipeline before low pressure gas filter shall not be less than Ф 10.

潤滑系統:

Lubrication system:

氣體機潤滑系統所有零部件及管路已安裝連接好，用戶不能進行調整；

All parts and pipelines of the lubrication system of the gas engine have been installed and connected, so the user cannot adjust it;

為保證氣體機機可靠工作，必須使用氣體機專用機油，嚴格按照說明書要求使用 GB級：CF-4/CH-4專用機油，允許用高質量等級的機油代替低質量等級的機油。

In order to ensure the reliable operation of the gas engine, the special engine oil for gas engine must be used. In strict accordance with the requirements of the manual, GB grade CF-4 / CH-4 special oil is used. It is allowed to use high-quality oil instead of low-quality oil.

冷卻系統:

Cooling system:

海水泵可隨機配帶或裝機，海水冷卻部分應安裝粗濾網、水濾網、止回閥，以上零件用戶自備。

The seawater pump can be equipped or installed randomly. Coarse filter screen, water filter screen and check valve shall be installed in the seawater cooling part, and the above parts shall be provided by the user.

進排氣系統:

Intake and exhaust system:

氣體機隨機帶空氣濾清器，用戶自備空氣濾清器時，額定流量應不小于規定值；外接排氣管盡量避免直角或急轉彎，管系背壓應小于2.5kPa。外接管路的重量不能置于增壓器上，應予以可靠固定。伸出艙外的進、排氣管口必須有防水及雜物掉入的裝置。

The gas engine is equipped with air filter. When the user provides the air filter, the rated flow shall not be less than the specified value; the right angle or sharp turning shall be avoided as far as possible for the external exhaust pipe, and the back pressure of the pipe system shall be less than 2.5kpa. The weight of the external pipeline can not be placed on the supercharger and should be fixed reliably. The inlet and outlet pipes extending out of the cabin must be equipped with water-proof and debris falling in devices.

電氣系統:

Electrical system:

主要由起動機、儀表、充電發電機、蓄電池（用戶自備）組成；

It is mainly composed of starter, instrument, charging generator and battery (provided by users);

蓄電池與起動電機之間的主連接導線截面積不小于70mm2，如果導線長度超過1.5m，截面應適當增大；

The cross-sectional area of the main connecting wire between the battery and the starting motor shall not be less than 70mm2. If the wire length exceeds 1.5m, the cross-section shall be appropriately increased;

機組儀表可根據用戶要求提供標準配置的機旁監控儀表、自起動監控儀表等。儀表箱嚴禁接到整流電源上。

According to the user's requirements, the unit instruments can provide standard configuration of local monitoring instruments, self starting monitoring instruments, etc. It is forbidden to connect the instrument box to the rectifier power supply.

選用遠程監控儀表時，遠程儀表必須與燃氣發電機組監控儀表配套使用，遠程儀表根據用戶合同供貨；

When selecting the remote monitoring instrument, the remote instrument must be used together with the monitoring instrument of the gas generating unit, and the remote instrument shall be supplied according to the user contract;

機組吊裝要求:

Unit hoisting requirements:

機組帶包裝吊運時，要將鋼絲繩掛在機組的包裝箱的護鐵處起吊，吊運過程中要保持機組平穩。

When the unit is hoisted with packaging, the steel wire rope shall be hung on the iron guard of the package box of the unit for lifting, and the unit shall be kept stable during lifting.

機組公共底盤上兩端各有兩個吊鉤或起吊環，吊運機組時要將吊鉤或鋼絲繩固定在起吊處起吊。起吊時要注意防護，不使機組受到損傷。吊運過程中要水平吊運。吊運要平穩、緩慢，嚴禁一邊起吊、拖拉及傾斜吊運。

There are two hooks or lifting rings on both ends of the common chassis of the unit. When lifting the unit, the hook or wire rope should be fixed at the lifting position. Pay attention to protection during lifting to avoid damage to the unit. Horizontal lifting is required during hoisting. The lifting should be stable and slow. It is strictly forbidden to lift, drag and tilt at the same time.

機組安裝要求：

Unit installation requirements:

為保證柴油發電機組正常工作，機艙必須具有通風措施

In order to ensure the normal operation of diesel generator set, the engine room must be provided with ventilation measures

柴油發電機組上方、柴油發電機組周圍要留有足夠的空間，以便柴油機操作與維護；

Enough space should be reserved above and around the diesel generator set to facilitate the operation and maintenance of the diesel engine;

柴油發電機組安裝底座應具有良好的平面度（≤0.25mm）及足夠的剛度，不得使發電機組的公共底盤發生扭曲。在安裝柴油發電機組時，必須用螺栓將機組固定在船艙內堅實水平基礎上，嚴禁將發電機組底座與機艙內機組支撐直接焊接在一起。

The mounting base of diesel generator set shall have good flatness (≤ 0.25 mm) and enough rigidity, and the common chassis of generator set shall not be twisted. When installing the diesel generator set, the unit must be fixed on the solid and horizontal foundation in the cabin with bolts. It is strictly forbidden to weld the base of the generator set with the unit support in the engine room directly.

柴油發電機組安裝時嚴禁灰塵、鐵屑、焊渣等物質進入柴油機進排氣管道內。

During the installation of diesel generator set, it is strictly forbidden to enter dust, iron filings, welding slag and other substances into the intake and exhaust pipe of diesel engine.

機組柴油機與進出水管、油管連接，需要用軟管過渡，不得將管路與柴油機進行剛性連接。連接軟管用戶自備。

When connecting the diesel engine of the unit with the inlet and outlet pipes and oil pipes, it is necessary to use flexible pipes for transition. The connecting hose shall be provided by the user.

本文由燃氣發電機組整理發布，您是不是對這些內容有所了解了呢?更多的內容請點擊：http://www.cxxrdz.com我們會有更多精彩內容等你查看。

This article is compiled and released by gas generator set. Do you have any understanding of these contents? For more information, please click: http://www.cxxrdz.com We'll have a lot more to see.